Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Like with every other project undertaken with this Jeep, axles are an unknown frontier for me. The closed knuckle 44 will be getting discs and I have...
Last post
I found replacement outer lock nuts with set screws at scoutparts.com. They look the same and I think the spindles should be the same so these should...
My power steering pulley was apparently un-detachable from the old pump that died, so mine is now shot. I located the replacement pulley on BJ's/TGW,...
Last post
got a new pump and ended up picking up a pulley from BJ's along with a new cap. works great
Anyone have an exploded view for the Vacuum Disconnect Dana 44 handy? I am trying to determine which seal I need to get. The drivers side (Side with...
Last post
Thanks for the link Jeff!!! I was able to find the exploded view I was looking for. From the exploded view, it appears as though there is a bearing...
I'm about ready to start re-assembling the axles and frame. So it's time I get serious about springs. I want a stock ride height and so the question...
Last post
New springs are fine unless they are abused hard offroad.
Personally even if I wanted stock, I would go with 2 springs. May not Sean like much, but...
I need to locate the proper bushing to go in the TOP of the shackle, where it mounts to the frame....
Last post
has listing for it. I've never worked with them but I heard if you call them they're helpful. Or if you can figure out their site it lists product#s...
So, I'm not really looking for a manual but how does it work? My Cherokee has the locking hubs on the front, so if I lock the hubs is it in...
Last post
Found it on Flint's site, great! It snowed 3-4 inches here last week so I finally got to confirm that everything seems to be working. I'll get it up...
I'm thinking of replacing my steering column with an aftermarket product. I haven't removed my steering column so I don't have any idea what it looks...
Last post
Hey Chief, glad you found us.
HERES A WRITE UP ON FIXING IT. uSE LOCK TIGHT ON THE BOLTS WHEN YOU TIGHTEN THEM AND YOU WONT HAVE TO DO IT AGAIN. ;)...
Does anyone know if I can use a stock Jeep underdash AC, stock drier, condenser, etc and have hoses made to mate it up to a late model GM compressor?...
Last post
If you were in the DFW area, I could tell you where a good hose shop is at. The Houston area will have them tho. check the yellow pages or internet.
Where does the tube come off the cat connect on the engine????
Last post
When I had it installed, I had it put on from the manifold back, new cat (2.5 I/O Magnaflow High Flow), an IMC Turbo Muffler, and out the back behind...
Well it ran fine last week every time I started it up last week when I came home from work, leave for the weekend and go to start it up yesterday it...
Last post
Yep had a partially plugged up fuel filter..slapped a new one on and it fired right up and purred like a kitten again...or roared since its just...
Of all the things I've done to vehicles over the years, freeze plugs are something I've never done. Seems pretty simple. Pop old one out, pound new...
Last post
Popping them out is easier than you think! Put a screwdriver or dull 1/2 chisel in the cup next to the edge and bang it with a hammer. The plug turns...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum