Hey all!
I installed my harness and never got around to actually plugging a window motor into it.
Finally installed my original window motor - it kinda worked slowly for 5-10 seconds then died.
I just assumed the OLD motor was had - couldn't ever get it to move again.
So, I bought a new/refurbished motor, installed it, powered it on, same thing... ran REALLY SLOW/weak (without the window installed, just on the arms) and within 5-10 seconds it died. I removed it from the bracket/arms/gears - plugged it in and tried to run it without any of that stuff - and the motor wouldn't respond at all.
I have a feeling something is wrong with the wiring and it's frying the electric motor.
Any suggestions/ideas??
Here's a photo of the harness/wiring installed without the motor:
I installed the two red wires in terminals 1 and 2 opposite of the blue wires - I'm 99% sure that's correct, but also wondering if that's where I went wrong?