https://www.ebay.com/itm/333113289504
I just figured I try them, I hooked them up to a battery real quick and the light pattern looks good, I'll try both of them in the garage soon to get an idea of the light output.
https://www.ebay.com/itm/333113289504
This is what it was, the color of the dash was not so bad, but accessories like carpet, seatbelts, and plastic elements were more like a terracotta orange to me, so I decided to go for an interior color change (stupid crazy decision and a ton of work)devildog80 wrote: ↑Tue Jun 28, 2022 8:47 am Nice job
I have Nutmeg dash on mine too, but truck not running yet, so will see when I actually spend time with it if it will need to be changed!
It looks from the picture you are missing the very bottom part there that has the last stud that keeps it nice and tucked to the dash.devildog80 wrote: ↑Tue Jun 28, 2022 9:14 am Not stupid crazy at all as you made it the way you want it.
On my dash, that left end that drops down by the door, is warped a bit and sticks out a little, from sitting closed up in AZ desert heat for 18 years.
Not sure, the surface seems to crack or tear easily. Belie that vinyl layer is just on a foam backing, the foam deteriorates and cannot support the hardening vinyl which in turn cracks. I think that in due time covering it with new vinyl or leather is the only way to go.devildog80 wrote: ↑Tue Jun 28, 2022 11:43 am Sounds reasonable
Is there a way to soften it up, so it is more pliable and won't crack, if I put pressure on it getting it back in place?
Or it might crack later being held in where it is supposed to be?