Okay, since Rick passed, the FSJ community lost a vital guru to keep our quirky rigs going.
I have followed his thread on IFSJA and was under the impression that his son would carry on.
It has been several weeks and no reply yet from his son.
Now, I completely understand that settling an estate will take time and this may be the delay. If this is the case and his son begins fabbing these, then the mods have total permission to remove this thread. I do not want to take away from someone else.
Also, Rick said many times he didn't make much off of these units. This may be a factor and his son just doesn't want to make them for so little.
His son may be busy like we all are.
Again, in any case, if he should start producing these, again this thread can be removed. I will not complain.
I take no credit for this. This is all Rick's Work. If there is an error, it is on my end.
I will try to add links to how-tos in the future as well as links to where to buy some of this stuff. In the mean time, I'd probably check out dell city for parts.
Others are welcome to add to or make corrections as needed.
Without further delay, I give you guys this:
I believe the bold colors should be 12 gauge and the thinner colors should be 14/16 gauge.