Hey Gang!
Im starting to think about shock placement on my Grand Wagoneer, and would appreciate some of your input.
Its an 84 and I installed 60" rear springs from a 95 Suburban and 93 Dodge W250 Dana 60 front and Dana 70 rear axles.
Here is the build thread if anyone is interested http://fsjnetwork.com/forum/viewtopic.php?t=5938
What I am trying is to use the lower shock mount from the 93 Dodge Dana 70 and, the stock 84 Grand Wagoner upper shock mount.
The shock was one that had been used on the 93 Dodge chassis, its just for visual purposes and will not be a "final" shock.
This is a view looking from the driver side.
This is looking from the front side of the rear axle toward the back of the Wagg.
Shock on upper and lower mount.
The shock sits at 4* with the top toward the back
6* toward the center of the truck
To me, the angles seem a bit too vertical.
I have a buddys' 93 W250 stored behind my shop with the exact same axles. I took a few pics of the rear suspension and checked the angles.
I could either build a new crossmember, or use the existing crossmember with new brackets to mount the upper shocks closer to the 30* of the Dodge.
If you have done a Chevy spring and axle swap, what angles are you using for your set up?
For the front, I could use the stock Grand Wagoner upper and the Dana 60 lower mount
The angle would still basically be the same as if I were using the Dana 44 that was originally there.
The front has a length of 27 3/4"
Any thoughts and pics would be appreciated.
Thanks,
Dan