Full Size Jeep Network

1980 Jeep Cherokee 2 Door. Amc 360 engine. T176 4 speed transmission. 4 wheel drive. Factory a/c set up. New MSD hei cap, rotor, and plug wires. New spark plugs. New MSD epoxy filled coil. Mr. Gasket distributor springs. New distributor rectifier. Rebuilt motorcraft carb. New battery. New air filter. New clutch. New transmission oil. Have a new oil filter and oil to do oil change. Replaced a lot of the rubber hoses so far. New belts. New rear main seal. New oil pan gasket.
Runs and drives but fuel pump went out. Have 2 new mechanical fuel pumps. Also have electric frame mount fuel pump and oil pressure sensor to upgrade to. Have 1 1/2 new rebuild kits for carb. Transmission does not like going into fourth gear, but works fine in other gears. Have new valve cover gasket set. Needs new shocks. Tires hold air.
Will need to be trailered. Would like $2500 for it. Will get some pictures soon. Will update post as I remember things.

Sent from my moto g power (2021) using Tapatalk

Here are outside pics. Also replaced the little flip out window on long side window on driver side. Rebuilt the oil pump with the kit from BJs.

Sent from my moto g power (2021) using Tapatalk

Engine pic.

Sent from my moto g power (2021) using Tapatalk

Ohhhhh I wish I wish I wish.......
If I had the money, time, and my wife was ok with it..........(salivating all over this thing), I would be there in a minute and bring it home!

Any chance of recording a video of it running, or driving it?

Interior?
Under carriage?

At work. Get more pics later.

Sent from my moto g power (2021) using Tapatalk

Looking forward to them.

Could post over here too for free on Jeep Forum.
Might need to sign up, and respond to others posts to get your membership validated, then you can post to Classifieds......I think.

https://www.jeepforum.com/forums/vehicles-for-sale.89/

Best of luck on the sale.

If it had 4 doors I’d done be burning diesel the 1300 miles to get there.

Yeller wrote:Best of luck on the sale.

If it had 4 doors I’d done be burning diesel the 1300 miles to get there.

I have a welder and plasma cutter! I can make it a 4 door!

Sent from my moto g power (2021) using Tapatalk

I would buy it in a heart beat but I promised myself and spouse that if I build another vehicle it will be 4 door so that it is more more convenient

Uggg submit button…

Convenient to share our adventures with friends and family

Fresh off the press. I also have a clean clear title for it.

Sent from my moto g power (2021) using Tapatalk

devildog80 wrote:Any chance of recording a video of it running, or driving it?

Sorry, trying to get time and a spot in my shop to fix fuel problem. So no running or driving video yet.

Sent from my moto g power (2021) using Tapatalk

That is nicer than I expected to see for the price.
If you can get it running, should be gone quick.....at least I think it should.

Id pick that up for my Off Road project if you weren't so far away! Id turn it into a Uni-body pickup, run 1 Ton axles, Rocklaurence Long Travel suspension and cut the fenders for 40's.

MrTea,
Sent you PM with my contact info.

devildog80 wrote:MrTea,
Sent you PM with my contact info.

Sent one back

Sent from my moto g power (2021) using Tapatalk

Hi,

I am 100% interested. Had a '78 before I was transferred overseas a few years ago. I can't figure how to PM you. Will try to figure that out for a few more minutes then will just put my email here.

Thanks you!