Blind bearing puller tools

This is a place to share about tools and workspaces
Post Reply
User avatar

Topic author
1978J10REDWHITE
Posts: 263
Joined: Fri Nov 20, 2020 7:25 pm

Blind bearing puller tools

Post by 1978J10REDWHITE »

Any advice on the blind bearing removal tools sets out there.

So for I found,
Orion looks like a cheap Chinese set , AMAZON site, the repots on it looks scary yet might work-maybe!
The OTC that I hope is good enough quality and has another version with the U-Puller yet $450++ costly,
Then the Snap-on, about in the middle of the road price but not sure quality of it.

Not sure which Dia tool span I need.

Application - BW1305/1339 T.C. in the 1978 J10.

SJTD
Posts: 1924
Joined: Tue May 21, 2013 12:02 pm
Location: Lompoc, Sunland or somewhere between

Re: Blind bearing puller tools

Post by SJTD »

I think I have one from HF. Their stuff is so inexpensive I tend to buy stuff, use it and forget I have it. I guess there's not enough pain from the purchase to make an impression.

I'll check tomorrow.
Sic friatur crustulum

'84 GW with Nissan SD33T, early Chev NV4500, 300, narrowed Ford reverse 44, narrowed Ford 60, SOA/reversed shackle in fornt, lowered mount/flipped shackle in rear.
Post Reply