Full Size Jeep Network

threepiece wrote: ↑Sat Apr 22, 2023 6:23 am

threepiece wrote: ↑Sat Apr 22, 2023 3:40 am

deckside wrote: ↑Fri Apr 21, 2023 3:30 pm Pre 1974 Roof rack or roof rack cross rails?

I have a roof rack assembly from a 1974 Wagoneer but none earlier. I’m curious to know the difference.

I was mistaken, the Wagoneer was a 1973 not 1974 it had an auto trans with Dana 20 T case. I believe I have the complete rack bundled up in between the floor joists of the barn. Let me know if you want pictures. I can send with email.

deckside wrote: ↑Sat Apr 22, 2023 4:02 pm

threepiece wrote: ↑Sat Apr 22, 2023 6:23 am

threepiece wrote: ↑Sat Apr 22, 2023 3:40 am

I have a roof rack assembly from a 1974 Wagoneer but none earlier. I’m curious to know the difference.

I was mistaken, the Wagoneer was a 1973 not 1974 it had an auto trans with Dana 20 T case. I believe I have the complete rack bundled up in between the floor joists of the barn. Let me know if you want pictures. I can send with email.

Yes please!

threepiece wrote: ↑Sun Apr 23, 2023 6:03 am

deckside wrote: ↑Sat Apr 22, 2023 4:02 pm

threepiece wrote: ↑Sat Apr 22, 2023 6:23 am

I was mistaken, the Wagoneer was a 1973 not 1974 it had an auto trans with Dana 20 T case. I believe I have the complete rack bundled up in between the floor joists of the barn. Let me know if you want pictures. I can send with email.

Yes please!

I have a rack here that you describe. It is complete with original stainless screws and gaskets looks in “good” condition with some pitting. $250 shipped to the lower 48.

I can send pictures if you give your email address.

deckside wrote: ↑Sun Apr 23, 2023 10:41 am

threepiece wrote: ↑Sun Apr 23, 2023 6:03 am

deckside wrote: ↑Sat Apr 22, 2023 4:02 pm
Yes please!

I have a rack here that you describe. It is complete with original stainless screws and gaskets looks in “good” condition with some pitting. $250 shipped to the lower 48.

I can send pictures if you give your email address.

sounds good threepiece, put my Email in a private message to you.

threepiece wrote: ↑Sat Apr 22, 2023 3:33 am

sierrablue wrote: ↑Fri Apr 21, 2023 9:30 am I'm guessing no early (pre-'74) Wag fenders? Or if you have a fender skin like BJ's used to sell (how is it they sell that stuff when I don't need it, and then when I do, it's gone????) that'd work too.

I had a 71 Wagoneer but I don’t remember what parts I removed. Most of my fenders are in an area I have not gotten to yet. Check back later, perhaps a month or two but no promises.

sierrablue wrote: ↑Mon Apr 24, 2023 11:48 am

threepiece wrote: ↑Sat Apr 22, 2023 3:33 am

sierrablue wrote: ↑Fri Apr 21, 2023 9:30 am I'm guessing no early (pre-'74) Wag fenders? Or if you have a fender skin like BJ's used to sell (how is it they sell that stuff when I don't need it, and then when I do, it's gone????) that'd work too.

I had a 71 Wagoneer but I don’t remember what parts I removed. Most of my fenders are in an area I have not gotten to yet. Check back later, perhaps a month or two but no promises.

OK, sounds good! Trying to think of other '71 specific bits I want...

Do you happen to have the full wheel covers from a Kaiser era Jeep? I'm thinking of using just the center "Jeep" part (it comes out, that way it was cheaper to manufacture and use the same exact piece with and without locking hubs) for center caps to slip between the axle and the wheel, to cover up the axle shaft in the back.

dljlobos wrote: ↑Tue Apr 18, 2023 1:26 pm Hello, Do you have any 1980 or newer J10 axles available? I'm looking for the front with the driver side drop Dana 44, and the rear centered AMC 20. Thanks

dljlobos wrote: ↑Tue Apr 18, 2023 1:26 pm Hello, Do you have any 1980 or newer J10 axles available? I'm looking for the front with the driver side drop Dana 44, and the rear centered AMC 20. Thanks

sierrablue wrote: ↑Mon Apr 24, 2023 2:20 pm These ones are what they go on. I'd prefer the Kaiser colors (as in the one I posted above) but whatever is ok.

sierrablue wrote: ↑Mon Apr 24, 2023 2:23 pm

dljlobos wrote: ↑Tue Apr 18, 2023 1:26 pm Hello, Do you have any 1980 or newer J10 axles available? I'm looking for the front with the driver side drop Dana 44, and the rear centered AMC 20. Thanks

I also have a pair (threepiece, I swear I'm not trying to steal customers)--if things don't work out, I have a driver's drop d44 and AMC 20 from an early '80s J10. Was gonna use them for a wide track swap on the '88, and never did. Just like threepiece said, no disconnect; had locking hubs originally.

threepiece wrote: ↑Mon Apr 24, 2023 7:43 pm

sierrablue wrote: ↑Mon Apr 24, 2023 2:20 pm These ones are what they go on. I'd prefer the Kaiser colors (as in the one I posted above) but whatever is ok.

Well, this reminds me of the covers that were on the 1973 Wagoneer but I haven’t a clue where they are at the moment. I have not seen them in more than a decade but I’m sure they are here somewhere. I’ll keep an eye open for them.

b00sted wrote: ↑Fri Jun 23, 2023 1:57 pm Looking for a set of round headlight buckets with trim rings

Stick wrote: ↑Fri Jun 23, 2023 9:22 pm Hello,

I am looking for a Roll Bar for a 78 J-10.

Stick wrote: ↑Tue Jun 27, 2023 5:38 pm I don't live near Detroit, but I will be visiting Delta, Ohio (which is pretty close to Detroit) the week of 17 July. I could come help get it out then.

You can text me at 770-317-7076

Thanks,
Jeff