Was going to order some new front floor panels here soon from BJ's, however i see where ZM has them for $20 cheaper. Anyone have any opinion either way as far as quality, etc? Here's the areas I need to replace:
I believe I need rocker panels too judging by the rust on the outside of the side body panel. There is a bit of rust on that side panel but i can't find them listed anywhere...i'll probably have a replacement panel made by my welding guy.
Also, I don't see any panels that can be used to replace this area: (up next to the seat)
is that going to be another custom-fab job too?
thanks in advance