It is a Ballistic Fab bumper,3/16 cnd bent unit sells for about $150.00 not bad.
Got some offers to take it off our hands since we don't have a JK.
So Started to work threw PM's with Brandon and this is how it looks now.
First up a winch hoop it is 1 3/4 .120 tubing bent at 45 degrees on each end. for bending I used a JD bender and I had a length of tubing laying around it took about 44".
Once the angle was chosen the ends were cut to fit flush and on to some gussets.
Choose some 10 ga flat steel again just left overs . Used a 1 1/8 hole saw for the main hole and standard drill bit for the smaller holes.
Next up was some tow points,decided to go with 1" blocks,but started with 1/2 x2 1/2 flat bar tac welded the 2 pieces together and started drilling the holes out 1 1/8 hole saw on the drill press and a little bit of time gives a nice cut threw.
Then cut a grove at the base and the center point to by fully welded to joint the 2 pieces.
After this everything was checked and welded up in all about 6 hours and 14 beers.
A little finish sanding and primer and it's good to go.
