Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
These patches replace the entire horizontal seam between the upper and lower panels of the J10 and J20 trucks. They are made from 18 gauge sheet steel and extent about 5” both above and below the seam. They are formed from one piece and shaped like the original bedside, including the weld flange to the bed floor for stiffness.
I can make upper patches that extend 9” above the seam for those beds with more damage.
Prices are $48 each for the short patch and $58 each for the long patch.
There are 2 patches for each corner of a bed. A complete set for the 7 foot bed consists of 8 short patches. A complete set for the 8 foot bed consist of 4 short and 4 long patches.
I have supplied these to BJ’s Full Size Jeep Parts but I will continue to sell these until my supply of shipping boxes runs out. Get them now directly from the manufacturer at a reduced cost.
I can send pictures through your email. Or, if someone would be kind enough to post for me I will send pictures to them.
I used to name my FSJ’s after their previous owners, I realized I had too many with five named Rick.
jjpeters4 wrote: ↑Sun Dec 08, 2024 9:01 pm
Do you happen to have any patches for the rear bottom part of the bed, the section below the rear tail lights?
Sent from my SM-A546U using Tapatalk
Not yet, I am working on this area below the tall lights. I have the tool designed and a surface gauge is made. Realistically I won’t have parts available before this year is over.
I used to name my FSJ’s after their previous owners, I realized I had too many with five named Rick.