I have a leak...

Stock FSJ Tech Area
Post Reply
User avatar

Topic author
44bz
Posts: 1081
Joined: Fri Jun 08, 2012 6:17 pm
Location: Oregon City, OR

I have a leak...

Post by 44bz »

Image
Sorry about the quality but I didn’t feel like crawling under there for a close up.

So I have gear oil leaking from the weep hole next to that silver disc. I’m assuming that means a bad seal in the axle tube?

It’s pushing out quite a bit of fluid, enough that after sitting I have a trail about 12 inches long on the pavement.

Such a bummer because replaced the wheel bearings and all the seals just a couple years ago. It was leaking then as well but a PO had siliconed everything including that weep hole so the fluid was leaking into the brake drum.


Sent from my iPhone using Tapatalk
1968 J2000 - AMC 327/T18/D20 (twin stick), stock D44s, 3" body lift, 35x12.50 Goodyear MTRs w/ Kevlar

1979bettywhite
Posts: 547
Joined: Tue Jul 25, 2017 8:14 am

Re: I have a leak...

Post by 1979bettywhite »

Yeah, looks like an axle seal to me. May want to inspect and see if something is causing it to tear or if there is a void somewhere in there. Should not be failing that fast. Is your vent tube intact and not blocked?

80Limited
Posts: 224
Joined: Tue Dec 12, 2017 7:32 pm
Location: St. Paul, Mn

Re: I have a leak...

Post by 80Limited »

Might be a bad wheel cylinder.
User avatar

Stuka
Site Admin
Posts: 11789
Joined: Thu May 12, 2011 5:53 pm
Location: CA
Contact:

Re: I have a leak...

Post by Stuka »

Check your brake fluid. If its low, most likely the wheel cylinder. If its fine, its an axle seal.
2017 JKU Rubicon
Pevious Jeeps: 1981 J10, 1975 Cherokee, 2008 JK, 2005 KJ, 1989 XJ

candymancan
Posts: 3652
Joined: Tue Mar 22, 2016 11:32 pm

Re: I have a leak...

Post by candymancan »

80Limited wrote:Might be a bad wheel cylinder.

Is it axle fluid or brake fluid. Have you smelled it ? If it smells like cat piss its gear oil brake fluid.. smells like i dunno but not like gear oil lol.
1998 Jeep Grand Cherokee 5.9L Limited 219k
1998 Jeep Grand Cherokee 4.0 I6 laredo 430k
1990 Jeep Grand Wagoneer 155k
1976 Jeep J10.. 85k(repaired)
User avatar

Topic author
44bz
Posts: 1081
Joined: Fri Jun 08, 2012 6:17 pm
Location: Oregon City, OR

Re: I have a leak...

Post by 44bz »

At first I thought it was brake fluid but since it’s coming from that weep hole I assumed it’s more likely gear oil because there’s splash shield over the end of the axle shaft intended to direct any leaking gear oil out that hole instead of inside the brake drum.

The fluid has color to it, but I haven’t smelled it. The brake parts were all replaced when I did the wheel bearings since gear oil had gotten in there.

I’ll check the MC for low fluid, that’s easy enough. It’s cold outside and we’re supposed to get a foot of snow so I dunno how quickly I’ll get to it. Dismantling the brakes in freezing temps and snow doesn’t sound very appealing...


Sent from my iPhone using Tapatalk
1968 J2000 - AMC 327/T18/D20 (twin stick), stock D44s, 3" body lift, 35x12.50 Goodyear MTRs w/ Kevlar
User avatar

Topic author
44bz
Posts: 1081
Joined: Fri Jun 08, 2012 6:17 pm
Location: Oregon City, OR

I have a leak...

Post by 44bz »

Well I smelled it, definitely gear oil. Guess I’ll be ordering seals. Nuts...


Sent from my iPhone using Tapatalk
1968 J2000 - AMC 327/T18/D20 (twin stick), stock D44s, 3" body lift, 35x12.50 Goodyear MTRs w/ Kevlar

twisted frame
Posts: 637
Joined: Wed Mar 27, 2013 9:41 am
Location: Massachusetts

Re: I have a leak...

Post by twisted frame »

That's no fun. Maybe the inspection pics will reveal something that caused it to bad, once it's apart. Bummer.
73 J4000. 360, MC 2100, T18A, D20, stock closed knuckle Dana 44 front, 60-2 rear. Warn Lock-O-Matics, Warn/Belleview electric winch, true duals with glasspacks, old-school front diff skid plate, used 265 Toyos on 16" AR wheels.
User avatar

Topic author
44bz
Posts: 1081
Joined: Fri Jun 08, 2012 6:17 pm
Location: Oregon City, OR

Re: I have a leak...

Post by 44bz »

Should I not drive it if leaking like this or is it fine? Obviously I don’t want to run out of gear oil. I don’t drive my gladiator very far, maybe 10 miles per week at the very most.


Sent from my iPhone using Tapatalk
1968 J2000 - AMC 327/T18/D20 (twin stick), stock D44s, 3" body lift, 35x12.50 Goodyear MTRs w/ Kevlar

twisted frame
Posts: 637
Joined: Wed Mar 27, 2013 9:41 am
Location: Massachusetts

Re: I have a leak...

Post by twisted frame »

I think driving it more could make the leak worse. It's probably ok to drive it if you need to but check the gear oil level maybe every other week. I'm also wondering if it could find its way inside the drum and screw up your brake shoes.
73 J4000. 360, MC 2100, T18A, D20, stock closed knuckle Dana 44 front, 60-2 rear. Warn Lock-O-Matics, Warn/Belleview electric winch, true duals with glasspacks, old-school front diff skid plate, used 265 Toyos on 16" AR wheels.
User avatar

tgreese
Posts: 7117
Joined: Fri Jun 08, 2012 6:31 am
Location: Medford MA USA

Re: I have a leak...

Post by tgreese »

Tapered or flanged axle? Could be either in 1968. The oil will have ruined the shoes, and you'll only have brakes on one side. This will result in wheel lockup in hard braking, but it's not much of a problem on the rear, especially the rear of a pickup. As long as the axle has oil in it, driving won't hurt the axle.
Tim Reese
Maine beekeeper's truck: '77 J10 LWB, 258/T15/D20/3.54 bone stock, low options (delete radio), PS/PDB, hubcaps.
Browless and proud: '82 J20 360/T18/NP208/3.73, Destination A/Ts, 7600 GVWR
Copper Polly: '75 CJ-6, 304/T15, PS, BFG KM2s, soft top
GTI without the badges: '95 VW Golf Sport 2000cc 2D
Dual Everything: '15 Chryco Jeep Cherokee KL Trailhawk, ECO Green
Blockchain the vote.
User avatar

Topic author
44bz
Posts: 1081
Joined: Fri Jun 08, 2012 6:17 pm
Location: Oregon City, OR

Re: I have a leak...

Post by 44bz »

tgreese wrote:Tapered or flanged axle? Could be either in 1968. The oil will have ruined the shoes, and you'll only have brakes on one side. This will result in wheel lockup in hard braking, but it's not much of a problem on the rear, especially the rear of a pickup. As long as the axle has oil in it, driving won't hurt the axle.
It’s a tapered Dana 44.


Sent from my iPhone using Tapatalk
1968 J2000 - AMC 327/T18/D20 (twin stick), stock D44s, 3" body lift, 35x12.50 Goodyear MTRs w/ Kevlar
User avatar

tgreese
Posts: 7117
Joined: Fri Jun 08, 2012 6:31 am
Location: Medford MA USA

Re: I have a leak...

Post by tgreese »

You can seal over the hub or the axle, as described in this post. http://www.earlycj5.com/xf_cj5/index.ph ... eal.78510/
If the surface you're sealing against is torn up, you may be able to switch. I'm sure there are members here and on IFSJA that have experience sealing the tapered axles. However, you could ask at earlyCJ5 - there are plenty of old posts there, and guys that have experience with the tapered axles.
Tim Reese
Maine beekeeper's truck: '77 J10 LWB, 258/T15/D20/3.54 bone stock, low options (delete radio), PS/PDB, hubcaps.
Browless and proud: '82 J20 360/T18/NP208/3.73, Destination A/Ts, 7600 GVWR
Copper Polly: '75 CJ-6, 304/T15, PS, BFG KM2s, soft top
GTI without the badges: '95 VW Golf Sport 2000cc 2D
Dual Everything: '15 Chryco Jeep Cherokee KL Trailhawk, ECO Green
Blockchain the vote.
User avatar

Topic author
44bz
Posts: 1081
Joined: Fri Jun 08, 2012 6:17 pm
Location: Oregon City, OR

Re: I have a leak...

Post by 44bz »

Thanks Tim. I’ll give Rich at r&p a call, see if he has any of those axle seals layin around. I don’t remember what I put on there before - a seal on the hub or the shaft. I’m sure i ordered from rockauto at the time.


Sent from my iPhone using Tapatalk
1968 J2000 - AMC 327/T18/D20 (twin stick), stock D44s, 3" body lift, 35x12.50 Goodyear MTRs w/ Kevlar
Post Reply