1984 Jeep Wagoneer seat removal.

Area for post regarding Jeeps other than an FSJ. This area may contain technical post regarding those vehicles as well.
Post Reply

Topic author
Rhballs17
Posts: 2
Joined: Sat Nov 30, 2019 11:03 am

1984 Jeep Wagoneer seat removal.

Post by Rhballs17 » Sat Nov 30, 2019 11:10 am

I am in the process of restoring a 1984 Wagoneer and I need to remove the seats so I can put in the new carpet. Does anyone have any advice on how the seats are removed? Do I need to cut a hole in the floor board in order to remove? Was hoping this was not the case. Thanks


SJTD
Posts: 1217
Joined: Tue May 21, 2013 12:02 pm
Location: Lompoc, Sunland or somewhere between

Re: 1984 Jeep Wagoneer seat removal.

Post by SJTD » Sat Nov 30, 2019 11:57 am

No need to cut holes. You should look at the underside of the vehicle where the bolts come through, wire brush them and apply your favorite stuck nut secrete stuff. Oil/solvent mix if you don't have or want to buy real penetrating oil.

Now that I think about it some bolts can't be reached from underneath so apply the goo from above. Better than nothing. Remove the carpet under the mounts if you can.
Sic friatur crustulum

'84 GW with Nissan SD33T, early Chev NV4500, 300, narrowed Ford reverse 44, narrowed Ford 60, SOA/reversed shackle in fornt, lowered mount/flipped shackle in rear.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest