Converting 86/91 control panel

Area for stock and aftermarket air conditioning.
Post Reply

Topic author
sonoraed
Vendor
Posts: 559
Joined: Sun Apr 07, 2013 7:38 am
Location: Sonora,Ca
Contact:

Converting 86/91 control panel

Post by sonoraed » Sun Jul 12, 2020 8:06 am

Image

Original hvac control panel 86/91 FSJ,
Because Vintage Air uses cable converters to control temp and function ( dash air /defrost/ floor) we need at least two levers , so going to cut the top off the back side of head
Blower is controlled by original indak switch


Sent from my iPhone using Tapatalk


Topic author
sonoraed
Vendor
Posts: 559
Joined: Sun Apr 07, 2013 7:38 am
Location: Sonora,Ca
Contact:

Re: Converting 86/91 control panel

Post by sonoraed » Sun Jul 12, 2020 8:14 am

Image
Image
Image

The new top piece is from sacrificed second panel, just screwed together and install cable converters
I believe the control panel were also used in newer Jeep Cherokee’s
Kit to control vintage air gen IV magnum is for a 1966 Pontiac GTO, did this 6 years ago so would need to check if kit is still designed to work with indak blower switch


Sent from my iPhone using Tapatalk


Topic author
sonoraed
Vendor
Posts: 559
Joined: Sun Apr 07, 2013 7:38 am
Location: Sonora,Ca
Contact:

Re: Converting 86/91 control panel

Post by sonoraed » Sun Jul 12, 2020 8:19 am

Image
Image

Tight fit but works with no problems


Sent from my iPhone using Tapatalk


Topic author
sonoraed
Vendor
Posts: 559
Joined: Sun Apr 07, 2013 7:38 am
Location: Sonora,Ca
Contact:

Re: Converting 86/91 control panel

Post by sonoraed » Tue Jul 14, 2020 6:13 am

Vintage Air no longer make a control panel kit that uses the standard 5 prong Indak blower switch, all signals to the GenIV module use VA cable controllers, may be able to still use the 66 GTO control panel kit, but I have not done so at this time.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests