Page 1 of 1
DATA INFORMATION
Posted: Fri May 22, 2020 4:58 pm
by DARREN LILLY
Hi how do I retrieve data information from the system to be analysed to find faults in the system. Is there any form of OBD. Thanks
Re: DATA INFORMATION
Posted: Fri May 22, 2020 9:19 pm
by KJ Ryu
What system?
Re: DATA INFORMATION
Posted: Fri May 22, 2020 9:40 pm
by Stuka
Yeah, need to know which EFI you have installed. Typically the answer is "yes".
Re: DATA INFORMATION
Posted: Sun May 24, 2020 3:50 pm
by DARREN LILLY
good point its a sniper, mine will die after about 20 mins of running with no indication of a problem then if left for a few hours will start straight away again good for another 20 mins, thermal breakdown? how do I get data info from this unit. Thanks
Re: DATA INFORMATION
Posted: Sun May 24, 2020 5:27 pm
by REDONE
DARREN LILLY wrote: ↑Sun May 24, 2020 3:50 pm
good point its a sniper, mine will die after about 20 mins of running with no indication of a problem then if left for a few hours will start straight away again good for another 20 mins, thermal breakdown? how do I get data info from this unit. Thanks
Does your sniper efi use the factory motorcraft ignition module? Because your description is textbook Duraspark failure.
Re: DATA INFORMATION
Posted: Sun May 24, 2020 5:47 pm
by Stuka
Yeah, sounds like a component is getting hot, and then fails until it cools. This is typical of a failing ignition module.
Re: DATA INFORMATION
Posted: Mon May 25, 2020 5:05 pm
by DARREN LILLY
running all holley equipment, distributer, coil & ignition module all new (but new doesnt mean good)
Re: DATA INFORMATION
Posted: Tue May 26, 2020 9:17 pm
by KJ Ryu
Sounds like ignition module to me, too.
Re: DATA INFORMATION
Posted: Thu May 28, 2020 2:36 pm
by 1979bettywhite
It's pretty easy to datalog with the sniper system. First you need the software for your PC:
https://www.holley.com/support/resource ... _Injection
Next you need to run a data log either with the dongle for laptop connection, or by starting a log on the touch screen to be saved to the SD card:
https://www.youtube.com/watch?v=rHjLwJQ45Kw
Also, make sure you remember to stop the data log before you cut the ignition. I believe this is fixed in newer versions of the software, but in older versions, the log would not have been saved if you cut ignition first.
When viewing a log with the Sniper software on a PC using the SD card, make sure that you first download the GCF file that the ECU is currently using to the SD card:
https://documents.holley.com/199r11031r.pdf (Page 72)
The Holley site and manual are great sources of info. I have learned quite a bit recently about the system, fine tuning, etc. from all their resources and forums:
https://forums.holley.com/forumdisplay. ... Sniper-EFI