I have the EFI mounted and plumbed in. Linkages connected.
I plan on swapping the distributor next.
Anybody have any recommendations on locating the ignition module and coil?
- Over at the Holley board they talk about proximity and interference. I didn't see too much about that in the instructions. Perhaps I need to re-read
- I was thinking about how best to lay things out so that my wiring is neat and clean. The PO left a mess with regard to original wiring
- My TSM stops at the wiring diagram section. I plan on removing anything that touched an old ignition component. Is this safe to say? Is there something i should watch out for?