J10 J20 2" tow hitch now available 1976-87

[cone]

Can you tell how far the receiver is below the frame? I have a Ford F150 rear bumper on my truck and I think it might drop a little lower than the original Jeep bumper. Also, how do you get the FSJ discount? Thanks

[rocklaurence]

It is 5" bellow the rear X-member. Yes, everyone on FSJ.net gets 10% returned [but you have to send me a reminder]. Also, note the additional Shipping charges West on Mississippi.

[cabz]

Can i get some pics and details on the hitch forvan 82 j10 lwb?
I am in desperate need of a hitch to tow a car i picked up.

Thanks
Cabzcell@gmail.com

[rocklaurence]

I also sent you an Email with instructions https://rocklaurencevintageautoparts.co ... ch-1975-87

[MRjerkyface]

Glad I found this post and the 10% discount, I am about to send an order your way for N. Alabama.

[rocklaurence]

Glad I found this post and the 10% discount, I am about to send an order your way for N. Alabama.

I received your order. However, Im out of town until the 19th of Jan. Ill get the hitch and discount sent to you when I return.

[rocklaurence]

Glad I found this post and the 10% discount, I am about to send an order your way for N. Alabama.

I received your order. However, Im out of town until the 19th of Jan. Ill get the hitch and discount sent to you when I return.

Sending your 10% discount to your PPal. Thanks for the Opportunity

[MRjerkyface]

Received the hitch yesterday and got it installed last night. Pretty straight forward installation although I did have a custom exhaust that required notching out the corner a little bit for clearance. I also used the extra two bolts and drilled to the tab that extends up beside the actual receiver which contacts the rear cross member of the frame. Only issue was on my side where that rear cross member was bent by PO. I did my best to straighten it when rebuilding but figured it wouldn't matter. I was able to bend that tab to get it to fit my bent cross member and bolted up.

I haven't pulled anything yet but I will say that Hitch is BEEFY! I am excited to have a solid hitch and glad I didn't have to go some universal fit route. Thanks Rocklaurence for a solid product.

[rocklaurence]

Received the hitch yesterday and got it installed last night. Pretty straight forward installation although I did have a custom exhaust that required notching out the corner a little bit for clearance. I also used the extra two bolts and drilled to the tab that extends up beside the actual receiver which contacts the rear cross member of the frame. Only issue was on my side where that rear cross member was bent by PO. I did my best to straighten it when rebuilding but figured it wouldn't matter. I was able to bend that tab to get it to fit my bent cross member and bolted up.

I haven't pulled anything yet but I will say that Hitch is BEEFY! I am excited to have a solid hitch and glad I didn't have to go some universal fit route. Thanks Rocklaurence for a solid product.

AWESOME