I have a set of ceramic coated Headman Headers off a 77 J10 with an AMC360. Think they will work for 71-79. I cut the driver flange so they can be installed without removing /replacing the oil dip stick tube. Passenger header contacted my driveshaft and has a dent in it (see photos) no holes but the coating was damaged in that area and there is a dent. This happened because my front suspension was so worn out (fixed now) the jeep was sitting lower then stock and super bouncy. the brown marks in the photos is oil not rust, I will clean before shipping. These only have 250 miles on them. I have 2 new gasket sets (they sent me two but I used remflex), brand new flanges and collector, hardware, and will include a collectors with an 02 bung in it.
MSD read to run distributor only has 300-400 miles on it ( I just switched to a Hyperspark to more easily control timing with my Sniper). I have most if not all of the adjustment springs, also comes with the harness. Will fit an AMC 290, 304, 343, 360, 390, 401
Headmans: $300 + shipping, OBO
MSD: $400 + shipping, OBO
I am in Denver.