Full Size Jeep Network

I guess I will put a thread to track my progress and get questions answered.

Looking at the picture I posted, is the bolt supposed to go through that plate with the nut on it? I assume so and the PO just didn't have the correct length bolt when he did the body bushings. Th carpet was screwed down and he didn't remove it to replace the bushings

working on cutting out the rust in the floor boards so i can weld in the new panels, and paint the inside of the cab

some metal work

Floors complete

Floors are done, seat is finished

Floors and seat look great!

Thanks, I hoping to get to drive it this weekend

Vinyl floor is in, seat is in, twinstick completed

Nice work on the floors!

Sent from my Pixel 2 XL using Tapatalk

working on my steps

Anyone know how much the Bed weighs? I and trying to decide if I want to use the tractor to lift the bed or another method.

Also whats the easiest way to remove the Metal trim piece from the back of the cab?


I have lots of updates and pictures to add. Just remembering to do it is difficult.

Got the steps painted, not going to install until I finish the body work and paint the Jeep. Still can't decide on a color

started doing the body work preparing for paint

Following as I am interested to see end results.

trying to get all the body ready for paint, have the paint already, just need to get my butt in gear.

Seat is in so......its time

"just need to get my butt in gear"

Fenders are ready for primer, body got shimmed so the fenders will fit correctly once they are primed. The PO put new body mounts on but didn't take the time to ensure the body was correct and level.

Fenders are primed (both sides)

painted fenders