Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
1979 Cherokee Chief S, V8, MSD Pro Billet Distributor with New Factory Ignition Box (are these 2 even supposed to work together?), HEI Wires, Edelbrock 1406, Edelbrock Performer manifold, 3.54 gears, Tru-Trac Locker in the rear, Turbo 400, New Quadratrac, Dual gas tanks, new 32 x 11.50's, Big 9000 winch, Homemade 2.5" full length exhaust, Custom Headlight Harness, Custom front bumper working, Custom Rear Swing-out Bumper, Class V receiver hitch ... and a lot of work to do yet.
akfuy09,
Good question. I have the 2 end pieces of my chrome factory bumper. When they are installed, only a small amount of this receiver hitch will show. I'm thinking I'll fab up a cover plate in the center so only the Square will poke through when done.
The reason I'm doing this is to have a Quick-Connect winch in a cradle that I dont have to haul around all year long. Only need it in the winter around here.
1979 Cherokee Chief S, V8, MSD Pro Billet Distributor with New Factory Ignition Box (are these 2 even supposed to work together?), HEI Wires, Edelbrock 1406, Edelbrock Performer manifold, 3.54 gears, Tru-Trac Locker in the rear, Turbo 400, New Quadratrac, Dual gas tanks, new 32 x 11.50's, Big 9000 winch, Homemade 2.5" full length exhaust, Custom Headlight Harness, Custom front bumper working, Custom Rear Swing-out Bumper, Class V receiver hitch ... and a lot of work to do yet.
Coming along. Not nearly finished yet. Going to fab up a Left and Right filler panel out of sheet metal. I can either chrome them or powder coat them when done. I also have to address the cutouts in the front valance where the P.O. had his winch brackets running back to the frame. Wish he didn't cut them up.
What do you guys think?
1979 Cherokee Chief S, V8, MSD Pro Billet Distributor with New Factory Ignition Box (are these 2 even supposed to work together?), HEI Wires, Edelbrock 1406, Edelbrock Performer manifold, 3.54 gears, Tru-Trac Locker in the rear, Turbo 400, New Quadratrac, Dual gas tanks, new 32 x 11.50's, Big 9000 winch, Homemade 2.5" full length exhaust, Custom Headlight Harness, Custom front bumper working, Custom Rear Swing-out Bumper, Class V receiver hitch ... and a lot of work to do yet.