edelbrock intake 3731-help

[Saul32]

Anyone running this intake can you give me a call? Have a question about the install
7737577413
I'm trying to finish it up today but can't seem to figure some vacuum connections out

[Gumby]

I currently cant help you, but I would like to see what it should look like I will be setting one up in the very near future.

But it may just be the same as the stock configuration .

[Mikeswagon]

I got that one just put on...what is it you want to know?

[Saul32]

Where does the brake booster get relocated to? And also the choke? The pcv valve goes into the port where the brake booster is on the stock manifold and there is no port for the choke..
Thanks. Text if you can

[Mikeswagon]

Sorry, hard to explain via text - i try these pics. I don´t know how a choke is operated by vacuum, so no help here. In the pictures you see:

1. to brake booster
2. PCV valve, you need a grommet for the valve. The valve itself goes in, used to be a hose to the valve on the oe...can´t remember anymore right now, anyway - here it is now.
3. No idea myself, just wondered a few minutes ago what to hook up there.... anybody else?

[carnuck]

Brake should go to the fitting right above the circled 3.

[Saul32]

Thanks guys. If you have any more pics I would appropriate it if you post em

[Saul32]

Mike what is the part in the port to the right of the pcv valve?

[Mikeswagon]

That is the hose to the heater (will be) In it used to be a dual CTO, that i changed to a single two port CTO.

[Saul32]

Thanks
If you have time can you post pics of the linkages. Trying to figure that out. Did you use. Any linkage adapters for throttle cable or trans kick down?