Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
I am working on rewiring my 83 Cherokee. I purchased a complete set of wire harnesses from Zach at Z&M. I wanted to see if anyone new the mfg and where I can purchase these connectors -
IMG_5946.jpg
IMG_5945.jpg
Thanks for all your help.
Mike
You do not have the required permissions to view the files attached to this post.
Do you just need the wire terminal or the connector and terminals? From the picture that you took, it appears to just be a Pack-Con I type connector. You should be able to reuse the connectors and use a removal tool to take out the old ones.
I will look through my inventory tomorrow for you on the three pin connectors. If you can post a better picture of the two way connector, I may have some of those on hand. The three way connectors I believe are not kept in stock in most every vendor I use or know of. I should be able to get you a part number tomorrow though. I just need to go out to my shop to get the part numbers.
I have the two ways in my inventory. If you can let me know how many of the three way types you need, I can check to see if I have any used 3 way male and female types still on a parts harness. Here is a picture of the two way types I have. 2waypackcon by Joshua Oman, on Flickr
refinemrh wrote: ↑Sat Jan 28, 2023 12:52 pm
I need (3) - 2 ways and (2) 3 ways.
I could not find any spare 3 way connectors. I do have enough brand new male and female 2 way connectors. For the 3 way connectors, if it helps. The part number for the female connector shell should be 08905205 and the male side should be 08905222. They are both made by Aptiv who used to be Delphi.
Why do you need those specific connectors? If the harness you bought replaces the original, it should plug in to your existing devices. If the harness did not match the existing connectors, I'd use WeatherPacks or something similar. There's nothing sacred about the original connectors.
Tim Reese
Maine beekeeper's truck: '77 J10 LWB, 258/T15/D20/3.54 bone stock, low options (delete radio), PS/PDB, hubcaps.
Browless and proud: '82 J20 360/T18/NP208/3.73, Destination A/Ts, 7600 GVWR
Copper Polly: '75 CJ-6, 304/T15, PS, BFG KM2s, soft top
GTI without the badges: '95 VW Golf Sport 2000cc 2D
Dual Everything: '15 Chryco Jeep Cherokee KL Trailhawk, ECO Green
Blockchain the vote.
I completely agree with Tim. If it doesn't plug into a specific component or device and just has a male and female connector end that connects the two wires together, you can pretty much use anything. I also like the weather-pack connectors for regular builds.
I appreciate the feedback. I am using weatherpack connectors in other areas. I like the low profile nature of these connectors for the dome and courtesy lights.
If you are looking to keep the Pack-Con, you could probably go with a 4 way in place of the 3 way. The 4 way connectors are much easier to find than the 3 way Pack-Con connectors.
I used the ZM harness and it was MOSTLY correct, but there were a number of instances where the connectors didn't match up. Am assuming that at some point there was some work done on my '84 because I saw chryco era connectors. Just swapped out with weatherpak and was fine.
If you're able to have a chance in keeping it original though, please do! I had a head scratcher. Don't be the future DSPO.