1983 Cherokee - Rear Seat

[refinemrh]

I am in the process of rebuilding my cherokee after a 3 year restoration. I may have misplaced the hw to attach the upright rear seat to the bottom frame. The TSM does not have any good diagrams. Does anyone have pictures or know what hw is needed?

Any help would be appreciated.

Mike

[tgreese]

Should be a picture in one of the parts manuals, free to read and download at the Tom Collins site. Looking at the '62-73 book, there's not much there. Group 29, plate 3 shows the seat, but there's little hardware. Uses a latch in later versions, but that's not what you are asking.

[refinemrh]

Thanks for the response. I will check out the parts manuals


Sent from my iPhone using Tapatalk

[letank]

Seat or bench? If bench I can snag a pict of the hardware

[refinemrh]

Bench

[letank]

these

RearBenchFrontSupportFSJx.jpg

Also do not tighten the bolts, there is some adjustments to center the bench, as seen here, the support holes are not round, so you can slide the supports as needed

RearBenchSupInstallFSJx.jpg

[refinemrh]

Thank you for the pictures. I have this hardware. I need some pictures or help with the hw that connects the seat back to the seat base.

Se the pictures:





Thank you for your help.

[letank]

Thank you for the pictures. I have this hardware. I need some pictures or help with the hw that connects the seat back to the seat base.

Se the pictures:

this is the hook that goes on the catch on the wheel well, #5805, the first pict -picts do not display right-

Thank you for your help.

not too sure about this one... I'll need to take a look at my bench, I have not dismantled one... only removed the cover!

[letank]

here we go for the articulation part, the right side,

benchHingeFSJx.jpg

[refinemrh]

Thank you for the pictures. This helps