TURBO 400 TRANSMISSION PARTS

[SOLSAKS]

1976 J10
NEED TRANSMISSION LINES
AND TRANSMISSION MOUNT
WHERE DO YOU BUY THOSE AT ?
dave in nc

[SOLSAKS]

got transmission mount from global transmissions in Michigan about 9 dollars
called in line tube ( the guys who made my fuel and brake lines ), not available.
going to see if the shop saved the old lines, if so in line tube can make them.

any ideas or suggestions would still be valuable to me.

thanx
dave in NC

[Stuka]

The lines are better off being made by hand. Buy some line, a flaring tool, and a bender.

[kep01]

I had hydraulic lines made for mine. They are flexible and can be routed anywhere you want


Sent from my iPhone using Tapatalk

[KJ Ryu]

I had hydraulic lines made for mine. They are flexible and can be routed anywhere you want.

I like this idea but, if I were to do it I would make sure the hoses are well protected from road debris, heat, etc. And I imagine you'd have to be VERY close in your measurements before getting them made.

[kep01]

I had hydraulic lines made for mine. They are flexible and can be routed anywhere you want.

I like this idea but, if I were to do it I would make sure the hoses are well protected from road debris, heat, etc. And I imagine you'd have to be VERY close in your measurements before getting them made.

The lines I used are for a tractor they are rated for over 1500 psi and are well protected already. As for measurement I just pulled a string from the trans to where I wanted them to go and added 6 inches to the measurements. Then took the old ends to the hose shop and matched the fittings and had them made.


Sent from my iPhone using Tapatalk

[SOLSAKS]

thanx for all the advice
I do appreciate it.
dave in NC:)

[tgreese]

You can buy a roll of tubing on eBay, cheapest place I have found. Lots of sellers, including Inline Tube. https://www.ebay.com/itm/OE-Zinc-Automo ... SwLmda1O-u Not difficult - these lines don't carry a lot of pressure.

[Jmontanio66]

Im looking for the correct modulator for 1979 wagoneer Th40O..parts store gave me (pioneer 747001) but will not
Push in..Trying do away with the elbow and put new style modulator..Thanks