Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
I'm planning to install TBI GM, I have two questions if someone is kind to help me with photos:
1 - Which solution did you use for the wiring...
Last post
What I did:
1) 2 Hole Saw. Once I had all the wires in I used a rubber grommet thing and a small army of zip ties. Bonus was I was able to easily pas...
Well next a fitech 400
Need best way to supply fuel to system - Prefer in-tank fuel pump for the EFI.
My 1981 Jeep J10 uses the original fuel tank...
Last post
Heck maybe just go with external pump. top pump and create opening sounds like a can of worms.
almost would want make a removable panel in the bed to...
Been having some intermittent issues with my Sniper. Sometimes it will run flawlessly. Then other times it will start popping, misfiring and swinging...
Last post
Not to mention that makes three 1970's in SD
Yes! Charles was telling me that. Are you up in Enc? I lived up there for years.
I have a lot of time and a bit of coin in the NP242 in my wagoneer, behind a 4l60e and the LT1. I want to go to a L96 and 6l80 or 90 at some point in...
Last post
Hey, thanks Stuka. I didn’t know the 242 was used in any of the gm family. Good to know.
I won’t abuse it when the front axle is engaged. I am sure...
I have a 1990 GW and I'm looking into getting a fuel injection kit installed. I did research online and ended up more confused than...
Last post
Honestly the GM system is hard to beat.
From an emissions standpoint ability to control the vapor canister and egr(with mods) of Howell(GM) system
No...
I am going to upgrade my stock 1979 Jeep Cherokee 360 to EFI. I am looking at the Holley and Howell systems. Looking for any advice on bets choice or...
Last post
TeaBag, you have any pics, tips, thoughts on an in-tank pump with your current setup? I have the MTS poly tank and an inline pump for my Sniper....
So as some of you may have followed and know, my 360 went off to be reman'd a couple weeks ago and it is now back and in. At the same time I had the...
Last post
Well, Holley wasn't that helpful, or maybe you would interpret as they were. They said basically the most improvement that can be made is to let the...
I will try to address the distr setup to clear up some of the misinformation, mostly being spread around the Jeep forums.
There are a couple guys...
Last post
8-) Bill, first thank you for your service and for clarifying the timing issue. Our jeeps are not daily drivers, just fun off road machines, legally...
I need help tuning my TBI set up. 7747 ecm and using Tunerpro. Trying to set the idle speed but I can't figure it out in Tunerpro. There seems to be...
Last post
There's quite a bit changed and some that should be but isn't.
I recommend you click the link and scroll down towards the bottom till you get to the...
I plan on doing an EFI swap on my 89 GW as soon as I can afford it, but I have to do drop my fuel tank and repair the frame above it and replace the...
Last post
Hey Guys- I have an 87 Wagoneer that Had a Holley sniper on it. Every time I hit the brakes at half a tank the car decides it is done. Will a power...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum