Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
So I need some advice to persuade me out of setting fire to my 79 Waggy and starting over!
I knew that the floor pans needed done correctly when I...
Last post
Looks good to me.
I replaced my floor pans back in 2003 and cut my rockers out in 2010 replacing them with 2 x6 tube..
NOt quite as bad as your pic's...
I am thinking about buying a complete 04 Chevy and take the drive train (engine/tranny/t-case) and swap them in. This looks like a cheaper way versus...
I'm not sure if this is ok in here or where to put it exactly so if it needs moved please feel free.
I bought the second row seat belt kit from ZM...
Last post
I figured if they ride too high on the neck that I'd get a set of those upper solid extensions that are used in full size vans. GM uses these for the...
I was just given a 14 bolt ff with 4:11's in it. I was thinking about doing the disc brake conversion on it as well as shaving the bottom off. In...
Last post
This is the California code on emergency brake systems... if the leak was at the master cylinder no problem... if it was at the wheel cylinder, well?...
im going to be welding the dana 60 rearend on the truck. its for hauling wood and offroading not a dd. i will drive it to the trail- most are within...
Last post
If you are doing it because your broke.... don't It will wind up costing you more in the long run. Weld it and run it. I have ran welded rears on the...
After receiving a few suggestions to upgrade to an HEI setup, but knowing nothing about them, what all is involved in the swap? When there is how-to...
Last post
My opinion is that the TFI and HEI are so damn close that you couldn't tell any difference if both are working correctly. I go for simple and you...
Here is what I am doing. I have two 1964 j-200 thriftside trucks. They are being combined to make one good truck. This truck will be for my daughter...
Last post
Thanks for feedback. I do plan to keep the Dana 20. Good feedback on the drum brakes. I've not been able to drive this truck so my only experience of...
Since I've put the 454 in my J2000 I can't run my a/c all the time in the summer. The engine creeps up in heat very slowly so the factory 4 row B-350...
Last post
well you have a, forgive me, bastard size rad. (if you have a 68-71 J2000)
the buick rads where the second in the size line, 327 being the first and...
I've wanted to build one of these for awhile now and decided to finally do it last weekend. Started off with cutting out a ring. Traced old cover and...
Last post
Typically if you change your fluid often you don't have to get every last drop out. Its mostly to get any contaminates out. And if you do need to get...
Wasn't sure where this fit the best, move if needed.
I'm adding a dual reciever tube mount system to the front of my waggy. Once it's finished I...
Last post
I managed to score a reciever hitch that, with minimal modification, will bolt onto the front of the frame. If I use that as the base for my mount, I...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
