Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
1979 J-10 with AMC 360 V8 is cranking but will not start.
I've troubleshooted the fuel and replaced the fuel filter and the mechanical fuel pump......
Last post
I will get the step down . Had to do over again... I would have soldered the #18(?) ignition wire to the #12 distributor wire and joined together. Oh...
When I got my 86 Wagoneer it has fuel controller that you manually turn knobs to adjust fuel delivery ( must of been first one holley ever made) Just...
Last post
i installed holly sniper and hyperspark, the thing is totally tunable from the drivers seat, f/a ratio, idle, timing, shows alternator out put, water...
I'm looking at fine tunning my front drive shaft angle with a double Cardan or is it just called a Cardan? Front axle is at 12.9 degrees, transfer...
Last post
The transfer case is sitting just about where it should be right now on clerance so maybe I should wait and drive it first once it's done, it's just...
So..., couple of questions on intakes. I know an Eddy performer will out flow an oem 4bbl intake, but just how drastic is the difference??
I ask cuz...
Last post
Will do that as just bringing it home I need to map out all the fittings needed, what is coming off the truck now, and overall fitment issues going...
Hi all, I am neck deep in a full restoration on an 80 Cherokee Laredo and wondered if anybody had added rear air ducts in the ceiling when installing...
Last post
Thank you for the work you do with Blue Ribbon, great cause and one that I support.
Hello all! First time posting! I have a 83 Wagoneer That I have big plans for. I have owned it for 6 years now. Finally am getting around to showing...
Last post
I mounted the unit out of a '92 XJ front to the brace the fsj one is mounted to. I had to be a little creative with the mounting but after 3 broken...
Hi all, I am neck deep in a full restoration on an 80 Cherokee Laredo and wondered if anybody had added rear air ducts in the ceiling when installing...
Read that there is an additional oil MOD for my 401 Block.
Incorporates Drilling a new oil passage from main cap to lifter oil passage, mirroring...
Last post
One thing I known since the 70's, was a deeper oil pan & P/U tube, for a better vol of oil and keeping it CLEAN and filter fresh is the life blood on...
For those who may be interested, this is what I did for my radiator. I've just been seeing a fair bit as far as cooling goes, so I thought I'd share...
Last post
I can appreciate the thought, but likewise, do not want to take it out of your pockets either :)
Hi everyone,
New to the forum. Searched everywhere to find a solution in the forum but this seems a bit unique. If you know another answer elsewhere,...
Last post
Yep.....have one kicking me too on my '84 GW. Pulled the neg battery cable between driving trips, until I installed a cutoff switch on the ground...
I'm hoping someone has run into this before. I searched the forums and found a few threads addressing failed tailgate key switches, but didn't see an...
Last post
Here is my write-up on what I did for an '88 Waggy. On mine I eliminated the safety switch as well as the keyed switch. But is could help.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum