Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Installing a new manifold on a freshened up 360. Any advice on the questions/challenges below?
Best sealant? RTV on the two rubber gasket sections?...
Last post
Yes, this is what works best for me. Also, if the tube gets a little distorted from the removal process, use the socket tool to support the inside of...
Have access to J20 axles from a 76 J20,
So pondering what it takes to swap them Into my 78 J10.
Width, D-line mount up, E-brake cables, leaf springs...
Last post
We all get dreamy just thinking of our own hoards, while talking to someone else about theirs :)
YUP,
I still have still from the mid 70’s looming...
I am going to install a holley sniper 2 efi system on my 82 wagoneer. I am looking to do the 97 blazer 2 door fuel tank swap in it so that I will not...
This is my first time posting on here and I am hoping that I learn a little something from the collective knowledge on here.
This...
Last post
i installed a 3 spring lift ,having removed a 4 spacer body lift ( it was jankey) and run 32x11.5x15's without any issue, however braking was not as...
So I'm reasonably sharp when it comes to electronics (like a rusty swiss army knife kinda sharp). I'm installing an MSD 6a and it has a dedicated,...
Last post
Thanks Tim,
I talked myself out of the tree, accepted the extra work to do it right and split the loom down so I could run the 10ga in the main loom...
Hello everyone. I will give a few lines about me first. I’m a retired heavy equipment mechanic in the pipeline industry. I go by the name of Bill And...
Last post
Now there is a bunch of Jeep money gone. Glad you were able to get the CAT and DEERE going again......damn animals, always having to clean up behind...
Not necessarily tech but definitely modified. I don’t know if anyone has done this much before but me and my brother got a hairbrained idea to make...
Last post
On the inside of the door, I welded a brace, arm protector, and now that it’s painted I put some 80 grit sand paper on it so you can also get in and...
Howdy, amigos. I'm not sure if my 258 is on its last legs or not. It seems to display a fair amount of blowby, but has 120 to 130 psi compression, 40...
Well I found a little something today. Ran across a post on Facebook saying that a guy put a 62 impala radiator in his fsj and it was pretty close...
Last post
This works in a pinch, but would suggest getting the proper radiator for your truck, when you order for dads replacement. I ordered one for my '84 GW...
I've been a member for a number of years now but my last post was quite a few years ago, back when I was in the midst of LS swapping my 91 Grand...
Last post
Stuka, tgreese,
Thanks for all your input. I tested my steering box yesterday. I can move my steering wheel between 11 and 1 o'clock and every input...
71 Wagoneer with Dana 30 closed knuckle front axle. Installing front disc brake conversion and the caliper hits my shocks just before full stop....
Last post
When I did the swap on mine (25 years ago?!?) I had a problem with the banjo bolt on the hydraulic line hitting the shocks with the wheels turned all...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
