Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Hi All, I've been building my 76 Cherokee and working through the last remaining issues with my new harness based on the '79 wiring diagram. I'd...
Last post
Simplest solution is to resize your pics and let the site host your pics. 800x600 should be ok. Lots of free apps for resizing - I use pixresizer on...
Has anyone retrofitted a combination brake light and cargo light like modern trucks have to where the cargo light mounts? If so what's worked and not...
The original flanged axle d44 in my ‘70 Wagoneer has a lot of play in it. Shifting into drive causes a loud “clunk” and with the drive shaft...
Last post
Ok, so as this area is outboard of the axle tube seal, you will NOT want to seal that area off. Sounds more like it is designed to be open to air, so...
Howdy folks, long time lurker not big poster. I drank the amc koolaid for the last 12 years and after much tinkering, rebuilding and efi'ing, along...
Last post
The full sized GM vans from the late 80s and early 90s with the OD transmissions can donate necessary column shift pieces (indicator) for your setup....
Was wondering what the best place is to pick up 12 volts for my new DUI distributor. Working on a 79 Wagoneer with a 360 engine. The attached pic...
Last post
About my J10 258, the distributor seems worn, lots of vertical play and his the right speed bump at the right speed and angle and it stalls.To renew...
Can anyone point me to information about converting my J10 (1982 258) to an electric fuel pump?
My problem: If the Jeep sits more than a few hours,...
Last post
I used an inline pump from airtex with a low psi output so I didn't need a regulator. My situation involved a 4.0 block though, so there was no mech....
Anybody have a pto winch on their fsj? I'm looking at adding a Dana 20 pto to my Jrtruck and just wondering how others have set theirs up.
Last post
Anybody have a pto winch on their fsj? I'm looking at adding a Dana 20 pto to my Jrtruck and just wondering how others have set theirs up.
Yep, on a...
I'm planning on tackling some body rust on my 76 J20 and came upon NOR/AM Body Parts out of Detroit. Specifically the side skins on bed. Anybody have...
Last post
I think that might be where BJ's Offroad gets their panels from.
Hey guys, I almost forgot to post up this project. The shop truck was rust free with the exception of the top. So, after driving it for 3 years with...
Last post
George updates me regularly. The Ugly Truck has a running LS, Lift, Big low profile tires and quad shocks. I hope to see it when its finished.
I've been having a shift issues with my TH400 transmission since I bought this '68 J-3500. Today I finally had time to look into it. Figured I either...
Last post
You can use a straight version.
Summitracing , $22. SUM-G110
Good for th350 and th400
Has anyone actually installed this ( on their Jeep/AMC V8? I have read lots of opinions from other forums, but I would like to hear from anyone who...
Last post
I've been watching his youtube channel for quite a while. I agree its more of a tool...but a cool tool :) I like that fact that it's so independently...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
