Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
I bought a really well preserved 76' J20 equipped with Emergency 4WD which I realize is basically a center diff locker. This truck is almost 50 years...
Last post
You CANNOT see the vacuum pod shaft move at the transfer case on a 1339. The shaft is completely inside the T-case.
Get on some grass field or dirt...
Making the best of a 2 spring lift that was installed by a P.O. many years ago... but eventually intend to return this '89 Grand Wagoneer...
Last post
I gix that rear end sag look. Id get a 1 inch lift block. Thats what i did. The quarter panel wheel wrlls sit lower so its an optical illusion. But i...
When I first bought my truck,(79 J10) all the gauges worked fine but most of the lights were burned out, i took the cluster out and replaced with LED...
Last post
I would also point out - the TSM is intended as a reference for professional mechanics and service managers working at the Jeep dealerships. It will...
I'm replacing the two vacuum lines on my transfer case vacuum shift pod and I noticed that the pod is able to be rotated freely. It's not necessarily...
Looking for recommendations on a replacement stock torque converter for a 91 GW with the 727. I don't really want to change stall speeds or anything...
Last post
Thanks all for the reponses. I called and talked to hughes today and there recommendation for me based on my CAM (Elgin E-912-P) was a 2K stall...
Friends, I am doing the preliminary research for installing the Howell EFI (st. legal version) in my J10. The truck is very stock, including the...
Last post
i have had several jeeps with the I-6 323 , 258 all had exhaust and intake gaskets i never had much problems with the exhaust gasket leaking as much...
well, the final piece of the minion hauler was completed today
after a decision to gut the orig.cruise control system electro-mechanical/vacuum junk...
I’d like to remove the steering column from my Wagoneer. The attached image shows the wires coming out of the column. Are those factory connections,...
Last post
You might consider putting some zip ties or something around either end of the plug--if you're working under the dash a fair bit the plug will like...
I purchased a used air cleaner for 360 in pics below in order to use instead of the aftermarket on there now. My truck is a 1976 that's had the air...
Last post
The outer door for the hot air supply is the same as was used in 1976, and is something you'll want to keep if you run a carburetor. You can disable...
1989 Grand Wagoneer/360 v8. New engine, fuel pump, wires, plugs, etc.
When the engine is cold, turn the key and it immediately seems to start, but...
Last post
Using the correct start procedure has the car starting in about 1/4 rev of the starter now. Thanks! I'll also be trying the RTV issue on the oil pump...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum