Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
I know the subject is a horrible description... when I open the rear passenger door, from the outside, the button that you depress will get stuck in...
Last post
Same here the other day... button is stuck solid,
Some pict for the next user's adventure, the rod is pretty rusted solid, soaking in anti-rust,...
Hey everyone. I've recently gotten my 72 Wagoneer back on the road, mostly. And thanks to a hydroboost kit and a front disc brake kit, it actually...
Last post
Manual transmission 79 and older wagoneers and Cherokees did not have a centered rear axle. All rear axles had some offset to clear the gas tank. But...
Does anyone know why the liquid check valve is located inside the vehicle? I have a slight fuel smell all the time that I've been unable to run down....
Last post
Ok, thanks for the replies. The o-ring appears good, the PO had the cap held on with a zip tie but the cap wasn't seated. I took it apart and cleaned...
The Fel-pro valley pan instructions, along with Edelbrock intake manifold instructions, say to apply Gascacinch to the head surface and underside of...
Last post
The rubber gaskets on any engine imo sucks.. toss em.. put a THICK layer of rtv on instead. Thick.. not thin or youll have leaks
Does anyone know a Nutmeg spray paint that will match the plastic parts on a 82Cherokee ? This truck has about every shade in the brown color palette...
Last post
The '62-73 parts book (free to read and downlaod on the Tom Collins site) shows these codes for '71 or older interior colors:
Hi all - my 1979 jeep cherokee chief wide track S just got its new motor installed. Stroked out 401; sounds absolutely incredible. But - I can't get...
Last post
Woohoo 🎉
I’d search “amp meter bypass” here and do that. there have been a couple of threads on that in the last couple of weeks. Do that, and...
While re-installing my rocker arms I broke a bridge (This was a routine head rebuild when I suspected a bad valve). The replacements available all...
Last post
I think the 3 piece design is better personally. I don't recall what year they were changed to the 3 piece. But the iron pivots are far more durable....
I just had a local shop rebuild my 401 heads. This is the first time I have ever done the heads independent of a complete engine rebuild. The 401 has...
Last post
You brought up a good point about vacuum leaks. When I rebuilt my first AMC engine in 1980 (304) the block was decked and I had coolant and vacuum...
PO pulled the original washer motor and left me with a yellow wire and red/white. I was hoping to use a universal motor/reservoir that pumps when it...
Last post
These circuits can be switched by switching power, or switching ground. There is no difference, except for how the circuit is connected.
My ammeter is holding around +30 while driving. It only occasionally drops back around 0 or slightly negative. It's a new battery, and I suspect the...
Last post
And volt meter should not fall to zero, it should show the output level of your alternator, while engine is running.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
