Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Hi all. My metal QuadraTrac emblem fell off of the tailgate on my 79 J10. Hey, it was on for 46 years so no complaints. I got all of the old original...
Last post
I don't think there is any alternative to the emblem tape for this application.
That should be how it was attached from the factory.
The 3M stuff...
So from what I can see in the manuals from oljeep and pictures of others engines, and the pcv valves coming up, I think something is funky with my...
Last post
The routing does not matter so much as having the devices connected correctly. As you discovered, the TSM discusses each system separately. There is...
I am troubleshooting my dome light wiring. The positive wire at the dome light has no continuity to its terminal on the headlight switch. So there's...
Last post
The B-pillar is where the J-truck dome light wire is.
Maybe not relevant - that's all I have to refer to.
You could look on the floor for a wire...
I've replaced every single part of the steering system on my 89 GW. Borgeson pump, redhead steering gear, TRW & Moog tre's and drag link, new upper...
Last post
Normally I just jack the front end up and rotate the wheel back and forth a bunch of times, it will eventually work the air bubbles out. Accomplishes...
I need a new boot for the clutch rod at the firewall. Can't find one online anywhere, but I do see ones for CJ's and some gm stuff. Does anyone know...
Last post
Thanks Tim. I have looked at that parts manual at Tom's site, (actually have it bookmarked!) and came to the same conclusions you did - with no luck...
Hey all, looking to replace the smoked steering shaft boot on my new column before I install it but I'm having a hard time figuring out which part is...
Last post
I used the GM boot shown in the pic from eBay. It matched the original boot in my ‘70 Wagoneer. You can see the original torn boot on the left, the...
For the leaf spring mounts in the rear, does anyone know the pin size ? I forgot what it was, need to order 1 inch blocks to level the drivers side...
Last post
Yea i found my old thread from like 6-7 years ago. I ordered 1 inch steel blocks for my gw. The pins were 9/16 on them snd it bolted right up to the...
Hello - The dash bezel with the wood trim on my wife's 1990 GW is cracked, so I bought a used bezel in good condition to replace the damaged one....
Last post
For anyone who is interested; the only way I could get the bezel out without removing the entire dash, was to drill out the plastic pegs by drilling...
So i already know adding more springs or coil over shocks doesnt increase total load capacity of youre vehicle.. you go by the gvwr and the weight of...
Last post
Your opinions are irrelevant, reality doesn't care about them. The stock shock mounts on these vehicles (or any vehicles) are NOT load bearing...
Hey all, so my vent window upper attachment point had the washers disintegrate and was going to break flopping around. I'm not sure how often they're...
I put a rebuilt motor in my Cherokee--broke it in correctly . I used the brake-in oil provided and ran it for half an hour with varying RPMs and then...
Last post
And 2 cents worth soooo much more than you know. Well worth the investment, for those of us chasing this issue.
Thanks for posting :)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
