Full Size Jeep Network

Now that I have shackle reverse on the honcho, it's time for a long travel front driveshaft.

I"m running a 1350CV on the Atlas tcase and a 1350 yoke on the D60.

What are some good (and inexpensive) long drive splines / yokes out there?

I don't think there is a cheap option. All the long travel shafts I have seen have been custom parts. Unless you use square tube.

https://www.facebook.com/pages/Tattons- ... 2630030274

You wont be disappointed for the price.

I've been using the same driveshaft guy now for years, so I went ahead and dropped it off with him.

He called me back and quoted just under $500 to get my existing 1350CV rebuilt with a long travel setup. I told him I needed 5" of compression and the rest will be droop. I figure that if Flint can get away with 1" of compression that 5" may be enough for the honcho.

with my new extended wheelbase, my front driveshat will be 34.5" yoke-to-yoke

Im afraid its going to be really close. I use about 6" total travel.

j20brett wrote:Im afraid its going to be really close. I use about 6" total travel.

well I'm going to have about 5" of compression travel and about 20" of droop travel. Is that not enough?

Blake wrote:

j20brett wrote:Im afraid its going to be really close. I use about 6" total travel.

well I'm going to have about 5" of compression travel and about 20" of droop travel. Is that not enough?

So the splined section is like 35 inches? Impressive if so. The splined section on my JK's front shaft is roughly 12".

Well, 25" of splined length ought to cover you lol.

http://www.driveshaftsuperstore.com/images/long2.jpg
http://www.driveshaftsuperstore.com/ima ... extend.jpg