Kick down linkage question

[SparkyB]

I'm getting very close to having the wagoneer on the road again thanks to perusing thread after thread of info. One thing I've noticed I don't have is part of the kick down linkage. In the picture it's part #4 where the thumb is. Is it a plastic washer/spacer? Can something be substituted in its place?

[will e]

Yes, I rigged something up so that it slides on there. BTW, it's not a kick down, its a TV. Adjustment is important.

[SparkyB]

Yeah I just searched tv linkage and saw some more pics but nothing specifically like I wanted. I assume it glides freely like a roller almost? Maybe a nylon spacer could go in the middle with a washer on each side? Small bolt to thru the carb linkage to hold it in place?

[Tatsadasayago]

If I recall correctly, the linkage was held onto the throttle shaft with a clip and two metal washers.

[derf]

I have a complete linkage that I took off my 360/727 a while back. It's just sitting there not being used. If you want it, I can get it to you for the cost of shipping and a couple of bucks.

[SparkyB]

I have a complete linkage that I took off my 360/727 a while back. It's just sitting there not being used. If you want it, I can get it to you for the cost of shipping and a couple of bucks.

Can you post a pic of it?

Sent from my LGL41C using Tapatalk

[derf]

I forgot to grab a picture last night. I'll try to get one tonight.

[derf]

Here's a shot.