Full Size Jeep Network

If it were me I'd just make cardboard cut outs of the template it's cheaper to mail that way

Or better yet, I'll just post a pdf people can print and transfer to the metal.

Sent from Tapatalk

Even better pal, now hurry up with it already

I'm on vacation 2000 miles away...home tomorrow. The beach has been my priority this week.

Sent from Tapatalk

Good for you, if ya like beaches.... I'm not a fan but my wife is..... She drinks blue moon too.

I prefer manly beers and the woods/mountains.

Ok, prototype is done. Need to clean it up and paint it. Had to weld on a little brace too. But I am really pleased with how it turned out. I think it will work well. Thoughts?











Sent from Tapatalk

Nice work Drew.

Looks good

Thumbs up!

Looks Great! Where are you going to route the cable?

E_DIGG wrote:Looks Great! Where are you going to route the cable?

To start off, I'm going to route it through the door jamb. I don't think it's tight enough to pinch it, then I'll take it through the back panel on the side up to the front. I've heard it said that if you are going to only drill one hole, drill it for the cable...but I'm still going to hold out and hope I don't get a kink. I technically could run it down through the taillight enclosure, or even hide it just inside the door and take it all the way to under the car or pass it through where the tailgate wire bundle goes through. But for now, I'm going to try through the jamb.

You could always use a bulkhead connector.

I am sorry. I was very specific that there should be a bottle opener option. I don't see it. Am I missing something????

I knew I forgot something! Of course, I only drink girly beers with twist off caps...if WWS is to be believed

will e wrote:I am sorry. I was very specific that there should be a bottle opener option. I don't see it. Am I missing something????

I thought thats what Bic lighters are for...

Could you make me two? One for each side?

will e wrote:I am sorry. I was very specific that there should be a bottle opener option. I don't see it. Am I missing something????

The key word is "option". This is the entry-level model with no options.

Have to add a ring for the gas cap chain also...

HowardT64 wrote:Could you make me two? One for each side?

It was a bigger pain than I expected and a lot of bend, try fitment, bend, try fitment. And I use the safety switch post as one of my mounting holes, which is only on the drivers side.

I'm wondering if I stopped by Firestick here in Phoenix if they would be interested in producing the design. If course, need to find out if it even works first...

TUDrewser wrote:I knew I forgot something! Of course, I only drink girly beers with twist off caps.

See he confirmed it