Just installed a skyjacker 4" soft ride lift on my 76 Cherokee. With the Jeep on the lift and the front axle at full drop, I cannot install the front drive shaft because it hits the stock exhaust. I think I have read about this problem somewhere before, but could not find anything about it on the forum. Is there a quick easy solution to this? I know I could just put the jeep on the ground and then install the drive shaft, but then every time I put it back on the lift it will hit the exhaust and bend it. I would rather not modify the exhaust because I like how the stock exhaust is tucked up under the jeep nicely. I was thinking of adding some axles straps. I would only need to limit full drop maybe 1 to 2" to fix this problem.
Has anyone else out there had this problem and what did you do to fix it?