16 Inch wheels

[akguy09]

I would like to find some narrow 16 inch wheels for my J-10...preferably something I can get from a pick and Pull/Junk yard

any suggestions to what makes and models people have successfully used or would fit? I did a search but the results were slim

[Yeller]

Pickings are going to be slim. 88 and newer GM 4x4’s are going to be about it.

[akguy09]

Thanks Yeller

[Stuka]

88+ GM wheels will not work. The center hole is too small to fit over the hubs. And the solid axle Blazer (up till 91) had 15" wheels.

The only wheels I can think of that work are Toyota. But they are all alloy wheels, not steel. And they are very clearly toyota.

[tgreese]

What's the needed center hole diameter? Looking at Summit, there are maybe a dozen different wheels with a ca 4" center hole, the right pattern, and what should be an acceptable back spacing (around 3.5"). Not junkyard cheap, but not thousands of dollars.

[Yeller]

Stuka is right…. I forget not everyone has a machine shop in the garage. I often forget some details that just don’t matter to me.

Later model Tacoma, 4 runners and pre 2000 Land Cruiser. And yes they look “Toyota” and typically are alloy and not steel.