Full Size Jeep Network

Hello. My name is Mathias. I come from Germany. Im planning to buy a 1969 Jeep Wagoneer 350 V8 that I would like to restore. The base of the Vehicle is actually quite good. However, some parts are broken or missing entirely. Maybe you can help me with that.

I need the following parts:

- Front left fender (driver's side)
- Engine hood (I'm missing this crossbar in the middle of the hood)
- The body is dented at the rear right below the taillight. I don't know if this is available as a spare part.
- Rear passenger side reversing light complete
- Chrome frame rear light driver's side
- Windshield (mine cracked twice)
- Front left driver's side bumper
- Petrol tank including lines and tank cap
- Jeep and Wagoneer badges around the vehicle
- Exhaust system
- Dashboard (mine is cracked)
- Hubcaps
- Razor front grille

Who has a source where you can get these parts cheaply?

Shipping parts to a US address may be is possible.

I am grateful for every tip.

How much should a car in this condition cost?
What do you think?

Best regards
Mathias

Here some more Pictures....

if it is moving on its own power and shifting gears, yes you can attach an external gas tank to the carburetor... been there, done it with a manual pump, the one used to prime outboard engine! minimal rust it could sell for $2K, not running a project with valid title offer $500.

The rear taillight are very hard to find, even the plastic lense inserts, the left one has been unavailable for a while at bjsoffroad, but some members might have spares they are willing to sell .

body parts, check bjsoffroad, IIRC they have body bits.

Found the listing... pretty clever gas tank replacement.... bored... waiting for paint to dry!

Did you end up buying buy this truck?