Page 1 of 1

Rubicon Run

Posted: Mon Aug 01, 2016 2:00 pm
by Fatbob309
A few friends from my Jeep club headed up to the Rubicon for a few days. My 81 Cherokee did great but had some issues even with all the time and money I put in so I wouldn't be that guy... I added a winch (it died as soon as I hit dirt), replaced the motor mounts 2 days before leaving ( one failed letting the motor/trans to flop and take out the front driveshaft) Put on a new lift (hit and broke a u bolt) and stuck with my 31's because they were like new. Should have done the 35's.
The carb died in Tahoe and no one had a rebuild kit or new carb. We found one in Reno at Summit so we made that drive after messing with it for most of the day.
Other than a few small issues the Jeep did great for being open and on 31's.
Here are some pics Chris from the HigherGround4x4 club got.
Image

Image

Image

Image

Image

Image

Image

Re: Rubicon Run

Posted: Mon Aug 01, 2016 2:06 pm
by AwesomeJ10
Nice!

Suck you lost a brand new MM. The new ones suck, just plain suck. I lost one this past Memorial weekend while on the sand dunes. Replaced it and lost it again 1 hour later. Replaced it again and stopped running the rig so hard.

Re: Rubicon Run

Posted: Mon Aug 01, 2016 3:02 pm
by srobertsfsj
Very cool, did you get a lot of body damage? Did you take the bypasses?

Re: Rubicon Run

Posted: Mon Aug 01, 2016 3:12 pm
by Fatbob309
srobertsfsj wrote:Very cool, did you get a lot of body damage? Did you take the bypasses?
Yes I did. Part if it was because I was on a strap for part of the trail after I lost the front driveshaft and had no control over what line I took. Not a big deal.
We went around little sluice but that was it. All the other stuff we did.

Re: Rubicon Run

Posted: Mon Aug 01, 2016 9:10 pm
by Stuka
What gears do you have? I am assuming stock 2.73's? Higher gears put a lot more stress on motor and trans mounts (as well as u-joints).

Very cool to see you made it through! FSJ's on the Rubicon seem so rare.

Re: Rubicon Run

Posted: Tue Aug 02, 2016 7:23 am
by Fatbob309
Stuka wrote:What gears do you have? I am assuming stock 2.73's? Higher gears put a lot more stress on motor and trans mounts (as well as u-joints).

Very cool to see you made it through! FSJ's on the Rubicon seem so rare.
Whatever it came with stock. It has ***almost*** enough power with that 4.2 to spin the tires in dirt... :D

Re: Rubicon Run

Posted: Thu Aug 04, 2016 3:21 pm
by Renodemona
Are you in town for HAN by chance? Doing a trail run Saturday in Reno if you're in town/able.