thanks for the infoStuka wrote: ↑Fri Dec 15, 2023 9:45 am For a wide track body, I know threepiece has been selling off a lot of his hoard. He used to have some bodies. Not sure if he still does.
You can maybe message and ask him: memberlist.php?mode=viewprofile&u=8809
Also, this guy was selling a WT project:
viewtopic.php?p=225446
yes that is correct . 05+ superduty unit bearings on all 4 corners . the rear flanges are wide open designrocklaurence wrote: ↑Mon Dec 18, 2023 2:11 pm Regarding the flanges for the rear D60, are you going with unit bearings? If so, what manufacture?
I looked at the site. Do you have to add a radial seal of some type or RTV to keep gear oil from traveling past the bearing and from leaking onto the garage floor?penski61 wrote: ↑Tue Dec 19, 2023 11:02 pmyes that is correct . 05+ superduty unit bearings on all 4 corners . the rear flanges are wide open designrocklaurence wrote: ↑Mon Dec 18, 2023 2:11 pm Regarding the flanges for the rear D60, are you going with unit bearings? If so, what manufacture?
i used seals it economy inner axle sealsrocklaurence wrote: ↑Wed Dec 27, 2023 10:46 amI looked at the site. Do you have to add a radial seal of some type or RTV to keep gear oil from traveling past the bearing and from leaking onto the garage floor?penski61 wrote: ↑Tue Dec 19, 2023 11:02 pmyes that is correct . 05+ superduty unit bearings on all 4 corners . the rear flanges are wide open designrocklaurence wrote: ↑Mon Dec 18, 2023 2:11 pm Regarding the flanges for the rear D60, are you going with unit bearings? If so, what manufacture?
link setup is 2"x.250 dom lowers and 1-1/2 x1.20 wall uppers with johnny joints , coilovers are just 10" travel universal fox 2.0 with 7/8" shaft