SJTD wrote:What happens if you just pull it in and clamp it?
How about posting a pic looking along the side from the rear?
I tried that first but it was causing the opposite side of the bend, toward the wheel opening, to pooch out.
I’ve cut some notches into the bottom edge and I’ve been trying to fold it over. Got it this far:
And pushed it the rest of the way in, held in place with clamps.
I think it’s good enough and should hold fine when I weld up the seam. What do you think?
Sent from my iPhone using Tapatalk
1968 J2000 - AMC 327/T18/D20 (twin stick), stock D44s, 3" body lift, 35x12.50 Goodyear MTRs w/ Kevlar