All,
Sorry if this is a stupid question but I'm ditching the factory carb and switching to a Motorcraft 2150. I thought I needed to do the nutter bypass? I have a 1982 cherokee with a 258, manual trans and the original carb does have the stepper motor on the back of it but I can't find the computer under the dash everyone talks about that gets bypassed. I'm attaching a pic that shows the only electronics I can find, it's all on the drivers side inner fender. I do have the orange and purple wires leaving the distributor but they are not twisted together and they look like they run into the silver box on the fender. Could I have a "stepper" carb but no computer? Not sure if I need to do anything or just forget the "nutter" and just put on the new carb?
Thanks!