Ok, here's one for ya,
I've got a TBI 350 with universal motor mounts from Novak-Adapt.
https://www.novak-adapt.com/catalog/eng ... s/mmx-wc1/
Drove over a few speed bumps and heard a a good clunk when the springs compressed. I know my springs are shot and just assumed that it was the axle hitting the bump stops. Turns out its the top of my differential hitting my motor mount.
Right now, I've got about 1 1/2" clearance between the diff and mount, and about 2 1/2" from my axle to bump stop. I know getting a longer bump stop will save my motor mount and 1 1/2" of travel isn't a whole lot.
So my questions are this:
Do anyone know of a prefab motor mount for a 350 that will provide the clearance needed?
Or (sacrilege) does anyone know of a 2wd front end set-up that will work on an 81 Wagoneer? I was hoping to go lower with the suspension than higher, and I don't tow or go off road anyway.