Transfer case on the driver side?

Area for General FSJ related chat.
Post Reply

Topic author
Smkozma69
Posts: 17
Joined: Thu Feb 07, 2019 1:11 pm

Transfer case on the driver side?

Post by Smkozma69 »

Just wondered why my transfer case lever is on the driver side when all other jeeps I’ve seen is been on the passenger side it’s a 1980 Jeep J 20 with a four-speed
Last edited by Smkozma69 on Fri Jun 14, 2019 2:06 pm, edited 2 times in total.
1980 J20 with Modified 360-60over, comp cam, roller rockers, roller chain, HEI distributor-T18, 4inch lift 37” copper stt pro’s on 20” ballistic wheels
User avatar

Stuka
Site Admin
Posts: 11804
Joined: Thu May 12, 2011 5:53 pm
Location: CA
Contact:

Re: Transfer case lever on the driver side?

Post by Stuka »

79 and older FSJ's have a passenger side drop transfer case, so the lever is on the passenger side.

80 and new FSJ's have a driver side drop transfer case, so the lever is on the driver side.
2017 JKU Rubicon
Pevious Jeeps: 1981 J10, 1975 Cherokee, 2008 JK, 2005 KJ, 1989 XJ
User avatar

derf
Posts: 1403
Joined: Mon Jun 04, 2012 9:10 am
Location: Littleton, CO
Contact:

Re: Transfer case lever on the driver side?

Post by derf »

1980 and newer J20 uses the T18a with a driver drop NP208. It's a J20 only combination. The J10, wagoneer, and Cherokee used a T177 4 speed manual with the NP208.

79 and older used several different manual transmissions over the years with the passenger drop Dana 20. There wasn't much exclusive to the older J20s.

Topic author
Smkozma69
Posts: 17
Joined: Thu Feb 07, 2019 1:11 pm

Re: Transfer case lever on the driver side?

Post by Smkozma69 »

That helps, thank you both for the info.
1980 J20 with Modified 360-60over, comp cam, roller rockers, roller chain, HEI distributor-T18, 4inch lift 37” copper stt pro’s on 20” ballistic wheels
User avatar

Fast79Chief
Posts: 449
Joined: Wed May 09, 2018 7:10 am
Location: Eastern Pennsylvania

Re: Transfer case lever on the driver side?

Post by Fast79Chief »

!979 Cherokee Chief with Quadratrac transfer case has the Low Range Lever on the DRIVERS side floor. !980 no longer used the Quadratrac transfer case.
1979 Cherokee Chief S, V8, MSD Pro Billet Distributor with New Factory Ignition Box (are these 2 even supposed to work together?), HEI Wires, Edelbrock 1406, Edelbrock Performer manifold, 3.54 gears, Tru-Trac Locker in the rear, Turbo 400, New Quadratrac, Dual gas tanks, new 32 x 11.50's, Big 9000 winch, Homemade 2.5" full length exhaust, Custom Headlight Harness, Custom front bumper working, Custom Rear Swing-out Bumper, Class V receiver hitch ... and a lot of work to do yet. :)
User avatar

Stuka
Site Admin
Posts: 11804
Joined: Thu May 12, 2011 5:53 pm
Location: CA
Contact:

Re: Transfer case lever on the driver side?

Post by Stuka »

Fast79Chief wrote:!979 Cherokee Chief with Quadratrac transfer case has the Low Range Lever on the DRIVERS side floor. !980 no longer used the Quadratrac transfer case.
Yes, QuadraTrac BW1339 had the low range shifter under the driver seat. As did later QuadraTrac NP219 and NP229 transfer cases.

But he was referencing the floor mounted shifter that is used with a manual transmission, in this case a NP208 transfercases that is up on the transmission tunnel to the left of the transmission shifter.
2017 JKU Rubicon
Pevious Jeeps: 1981 J10, 1975 Cherokee, 2008 JK, 2005 KJ, 1989 XJ
Post Reply