Hey guys,
Trying to get everything I need to fully rebuild my rattly tailgate... again... and am a little confused about the moulding the glass is attached to. I don't know if this changed over the years but on mine, as it is right now, the glass was just held into the moulding by glue. In some other pictures I've seen though it looks like there's a piece of foam 'cushion' that lays inside the moulding, keeping the glass from making direct contact with it.
Is that something they had across the board or was that setup added later? On TGW and BJs I can't seem to find that specific piece of foam. In searching the forum, I think I found some mentions of it, but nothing that seemed definitive.