Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Installing 6.5" Infinity Kappa door speakers on my truck which orginally didnt have anything but the single dash speaker and was just wondering how people have routed the speaker wires from the door to the cab. There is no boot between the two and i am looking to get a clean install without any chance of damaging the wires. Suggestions?
There isnt really a boot on my 90 either.. Just some plastic curved shield.. Id just cut a hole into the side of the door.. get a round rubber thingy ( forgot their names) so the hole doesnt cut the wires.. and route it through the fender into the Jeep from the firewall and id just wrap it in electrical tape .. Keep it long enough to ope the door but not long enough so it pinches.
But thats just me
1998 Jeep Grand Cherokee 5.9L Limited 219k
1998 Jeep Grand Cherokee 4.0 I6 laredo 430k
1990 Jeep Grand Wagoneer 155k
1976 Jeep J10.. 85k(repaired)
Fwiw, I found a pair of marine speakers at best buy (iirc). They had built in LEDs of several colors. Put them in the Xj and they sounded great. Inexpensive. Water proof. And added a little illumination if I turned them on.