Checked around a few places for a new set of stock springs for a 78 Waggie and ended up at Alcan. Bill was super responsive to an email request and the next day I put in the order for a newly made stock height set of springs with an extra 400lbs load built into the rear springs for mild towing duties (one extra leaf).
Alcan expects to have them made and delivered in 3 weeks, will report back when received and installed, but very pleased with their responsiveness, knowledge, and that they are Colorado made springs. A bit more expensive than others but was willing to pay to play. Alcan already had all the dimensions eye to eye, front to back, width, and capacity for our rigs.
Others either have Crowns for stock height, or in the case of the +2” lift from BJ’s I had previously waited for nearly 3 months as they were being made and had no hard estimate of turnaround so ended up cancelling. BJ’s now expects them in sometime soon and the +2” are being made by Deaver.
Otherwise, in stock US rear springs were nearly impossible to find at stock height or mild lifts from everywhere including General, SD, others. The 4” lift kits from Rustys, Rough Country, Skyjacker are readily available but I was not looking for a lifted setup.