About to finish the plugs, wires, coil upgrade in my 78 Cherokee with 360.
It has the factory Ignition Control Module - which is new, all the epoxy melted out of it with the previous owner - but is still working.
I am installing the MSD Blaster 2 coil.
Studying the wiring diagram, I see a "Capacitor Jumper" drawn and attached to the + side of the coil. Where would it be in the vehicle?
Do I need to install the capacitor that came with the MSD Blaster 2?
Also, the existing coil has the factory clips for the + and - attachments - so they will be replaced with the new terminals.
Any advice for aftermarket coil noob?