Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Need to replace my fuel pump but dont know what PSI I need. I have a fuel injected 4.2L with the Clifford 6-8.
Engine - 258
FI - Mopar
All Factory - No
Add on - Yes
Pump is external, cant find a part number but I believe it was for a carb which might explain a few other issues.
89 GW 360/727/208 (soon to be LQ9/727/208) MSD 8523 Pro Billet Distributor, MSD 8207 Blaster SS Coil, 30x9.5x15 Destination M/Ts, Warn Lock Out Hubs
"I don't always downshift, but when I do its next to a Prius so the driver can hear me hurt the environment."
Jeeps don't break down, they're just extremely demanding when they need parts replaced!
I'm sure it doesn't help much but I had a Holley pump on my old ram charger with the regulator on it and it ran great like that....you can get it dialed in just right....
Have you put a pressure gauge on it to see what it is now? I would start there. I recently put a new electric pump, NAPA generic, on my GW and found that even though I had nice pressure for a carb at 8-9 psi, the volume could not keep up with 401 consumption. I went back to the AutoZone pump at 3.5-4.5 psi and doing fine. Some experiences vary...