Full Size Jeep Network

Hey all, as time goes on I've gotten to the point of having my own web page I have approximately 150 items on the store and will be adding more every day. The discounts and free shipping deals will exceed what's on my Ebay listings. Please visit my web based store and let all the enthusiast know where to find it--Thanks
http://www.rocklaurencevintageautoparts.com

I will have the proto type Wagoneer tow hitch done Tuesday.. It'll be less than $300 free shipping

rocklaurence wrote:I will have the proto type Wagoneer tow hitch done Tuesday.. It'll be less than $300 free shipping

I should pick up the parts from the Fab' shop Monday and hope to have the first Wagoneer tow hitch done next week.

rocklaurence wrote:I will have the proto type Wagoneer tow hitch done Tuesday.. It'll be less than $300 free shipping

Now selling the best-built hitch available for the Wagoneer SJ Cherokee!!!

http://rocklaurencevintageautoparts.com ... 2-receiver

OK, after much trial-n-Error I now have a NP229 twin stick shifter for sale..Check it out and it will fit trucks and Wagoneers with the NP229, eliminating the vacuum system and original flag shifter.

Looks Great, How much are is it?
Is there enough travel on range selector that neutral is easy to get?
Did you incorporate the stock bracket on T-case?

J.Bradley wrote:Looks Great, How much are is it?
Is there enough travel on range selector that neutral is easy to get?
Did you incorporate the stock bracket on T-case?

The bracket and Vac module are removed. Two replacement links tie into the new shifters. I wanted to get it posted up on the sites but I will have better pictures soon as I develop the install instructions. It'll also work with 2-3" body lifts..

As good as the shackle reverse turned out I am excited for the shifter upgrade. I had to weld a brace on my vacuum actuator bracket because it would actually flex the bracket instead of switching from 2 to 4. I use neutral for towing behind motorhome and use 4x4 lever mainly for that instead of off-road.

Also note: because of the set up the lever actions is the opposite of most other Tcases. Necessitating custom knobs.

That looms great.... we need a rate$ please.

I'm in the process of calculating the cost. Unfortunately, there is a lot of work required to cut the materials, engrave the knobs and assembly. They wont be priced similar to a D20/D300 twin stick at $100 but closer to $200.

Let us know when they are ready....

I would love something like this for my Quadra trac with low range .. ??
Just so I know I'm in " Emergency Drive"
Thanks

Gumby wrote:Let us know when they are ready....

They are available [sold 3 already]
http://rocklaurencevintageautoparts.com ... k-or-wagon

orange wrote:I would love something like this for my Quadra trac with low range .. ??
Just so I know I'm in " Emergency Drive"
Thanks

Sorry, no plans for a Quadratrac unit.

Will your tow hitch fit on the early wagoneers; like 1963?

66stepside wrote:Will your tow hitch fit on the early wagoneers; like 1963?

I'm not sure. What is the on-center width of the rear frame?

33" center to center.


Sent from my iPhone using Tapatalk

66stepside wrote:33" center to center.


Sent from my iPhone using Tapatalk

My hitch mounts holes are 35" apart that put the bolts centered on the frame flange. Was your measurement 33' from inside edge of frame to the inside edge of frame? If so. the hitch is 33" inside to inside and 35" to the center of each frame rail.

Wagoneer trailer hitch CLOSE OUT sale!!! I'm practically giving these away at this price and free shipping East of Mississippi!!
http://rocklaurencevintageautoparts.com ... 2-receiver